Extension(s) must have TAFAS enabled in their COS.

(Remember, 'nite bell' is 'night' in name only) Then do TAFAS (Trunk Answer From Any Extension) from extension or console. The only way to accomplish these at the same time is to direct all calls to a night bell. Remove all unused trunks from the trunk group, probably trunk group 1.Ģ. I know that was a lot to ask in one post, but any help is appreciated. Just wondering if anyone knows a 'quick' fix before I start troubleshooting. Could that be a parity issue, or a baud rate issue? The printer seems to be quite advanced as far as dot matrix printers go, but it is from the same vintage, ca. However when hooked up to the Mitel system, it does nothing.

I have a Citizen GSX-230 dot matrix printer that is in good working condition. Can I set up a ring group to have a certain number of phones ring when an incoming call comes in (in addition to the console ringing without having to put it in night or overflow)?Ĥ. I would also like to be able to answer the trunk from any extension, regardless of if that extension was ringing on the incoming line.ģ. Trunk-73 for all outgoing calls and for it not to 'hunt' for an open trunk?Ģ. Is there a way to 'force' the system to always use one trunk, i.e. I have 2 LS/GS trunk cards in the system, however I'm obviously not using them. Incoming calls I'm not having much issue with, however when I want to make an outgoing call, it always seems to go to a trunk that is not being used, therefore putting the system into alarm.

On my SX-50, I have a standard incoming phone line coming into the LS/GS trunk card.

Driver printer citizen gsx 230